![]() There is presented crack width according to colour in the legend too. ![]() The drawing setup depends on selected value, where for Check value and for values w, w- different drawing setup is used.įor presentation of all values in legend it is necessary to switch off check box User defined values in dialog Maximum and minimum settings. The direction and size of crack width will be presented in graphical window where direction of crack is perpendicular to direction of principal stresses. ![]() The unit check will be presented in numerical and graphical window, where. The value is always calculated and presented in the centre of FEM element and for whole FEM element the results are the same. User reinforcement can be defined via reinforcement 2D, free bars, concrete member data (the reinforcement is the same for whole 2D member). The explanation of symbol is presented too above the command line after selecting the cells in the table, see picture below. This property is available only in service Crack control in document. These explanations are available in dialog Calculation info which can be opened via action button Calculation info. The following load casescombinationclasses are supported (filtered).
0 Comments
Leave a Reply. |